How to make a pendant lamp from a old phone charger

How to Make a Pendant Lamp from an Old Phone Charger.

To make a pendant lamp from an old phone charger, you first need to cut the charger. Cut the phone charger in half so that you have two pieces of plastic. Then, peel off one of the covers from the bottom of the phone charger and peel off the label on it. Now, cut a hole in one end of each piece of plastic and insert it into the cover on the bottom of the phone charger. Now screw these pieces back onto the top of the phone charger.

How to Assemble the Pendant Lamp.

Once you have cut and screwed your pendant lamp together, you next need to assemble it. Put one end of your pendant lamp over one end of youroriginally designed USB cable and then screw it in place using screws supplied with your pendant lamp. Finally, put another end over this newly created USB cable and screw it into place as well.

How to Use the Pendant Lamp.

The final step is to use your pendant lamp! Plug it in to an electrical outlet and enjoy your beautiful light!

How to Make a Pendant Lamp from a Cord.

To make a pendant lamp from an old phone charger, you’ll need to cut the cord. Cut the cords long enough to reach the back of the pendant lamp and then slice them in half so that each half has a cord attached.

How to Cut the Cord

First, find where the power cord is connected to your phone. Cut off one end of the power cord and then peel it away from the phone. Slice the power cord in half so that one half remains attached to the phone and use it as a starting point for cutting the other half of the cord. Be sure not to cut into any metal parts of your phone!

How to Assemble the Pendant Lamp

Now that you have both halves of the Cord Cutter, it’s time to assemble your new pendant lamp! Start by attaching one end of each cut-off cord to one end of a light bulb (or other electrical object). Fit everything together securely and then screw them in place using c screws (if using electronic devices).

How to Make a Pendant Lamp from a Stone.

First, cut the stone into a suitable size for your pendant lamp. Choose a size that will fit comfortably on your wall and is not too large or small. Next, use a saw or diamond cutter to cut the stone into desired shapes. For example, you may want to carve out a small pendant lamp or design it inlay with colorful stones.

Next, assemble the pendant lamp using the following steps:

1) Place the stone on top of the battery charger and screw in place.

2) Turn on the power to the charger and wait until the light begins to flash.

3) connected your phone’s cable to one end of the Stone Pendant Lamp Charger and your phone’s charging cord to the other end of the Stone Pendant Lamp Charger.

4) Hold up your phone and watch as light travels from your phone’s battery to theStone Pendant Lamp Charger and back again.

Leave a Reply

Your email address will not be published. Required fields are marked *